146 U8903A User’s Guide
Appendixes
There will only be one set of [] if the filter type is FIR. The
IIR filter contains multiple [], where each set of []
represents one section.
You may set up to 256 coefficients for the FIR filter type,
and up to 36 sections for the IIR filter. The number of FIR
coefficients must not be less than four, while the minimum
number of sections allowed for IIR is one (seven
coefficients). The delay is specified in the form of samples
and within the range of 0 to 65535.
It is recommended to use commas to separate the
coefficients. However, newlines can also be used as
separators.
To Next Page
Loading...
Need help?
General
