70 U8903A User’s Guide
4 Audio Generator Functions
Audio Generator
Press on the Mode panel to access the audio
generator settings page.
Select the active channel to start configuring the channel.
You can perform a channel selection by using the arrow
keys.
The generator waveform functions are listed as follows.
These waveform functions are accessible by pressing the
corresponding softkeys.
• Sine
• Variable phase
• Dual sine
• Dual
• SMPTE IMD 1:1
• SMPTE IMD 4:1
• SMPTE IMD 10:1
• DFD IEC 60118
• DFD IEC 60268
• Noise
• Gaussian
• Rectangular
• DC
• Multitone
• Square
• Arbitrary
To Next Page
