Getting Started 1
U8903A User’s Guide 11
Installation and Configuration
Initial inspection
When you receive your U8903A, inspect the unit for any
obvious damage such as broken terminals or cracks, dents,
and scratches on the chassis that may occur during
shipment. If any damage is found, notify the nearest Agilent
Sales Office immediately.
Keep the original packaging in case the U8903A has to be
returned to Agilent in future. If you return the U8903A for
service, attach a tag identifying the owner and model
number. Also include a brief description of the problem.
Ventilation
The U8903A can operate within the temperature range of
0 °C to 55 °C. The U8903A is cooled by drawing air through
the sides and rear and exhausting it through the ventilation
holes on the top, sides, and rear. The U8903A must be
installed in a location that allows sufficient space at the top,
sides, and rear for adequate air circulation.
Rack mounting
The U8903A can be mounted in a standard 19- inch rack.
Rack mount kits are available as Option 908. Support rails
are also required for rack mounting. These are normally
supplied with the rack and are not included with the rack
mount options.
If you are installing an instrument on top of the U8903A,
ensure that the instrument does not obstruct the ventilation
holes at the top side of the U8903A. If required, use a filler
panel above the U8903A to ensure adequate space for air
circulation.
To Next Page
Loading...
Need help?
General
