Alcatel-Lucent 7210 SAS-X - Page 190

VLL Services Command Reference
Page 190 7210 SAS-X, R6 OS Services Guide
Epipe Spoke SDP Configuration Commands
config
— service
— epipe service-id [customer customer-id] [create] [vpn vpn-id] [svc-sap-type {any|qinq-
inner-tag-preserve}] [customer-vid vlan-id] [pbb-epipe] (for 7210 SAS-M and 7210 SAS-T
in Network mode)
— spoke-sdp sdp-id[:vc-id] [vc-type {ether | vlan}] [create] [no-endpoint]
— spoke-sdp sdp-id[:vc-id] [vc-type {ether | vlan}] [create] endpoint
— no spoke-sdp sdp-id[:vc-id]
— accounting-policy acct-policy-id
— no accounting-policy
— [no] collect-stats
— [no] control-word
— control-channel-status
— acknowledgment
— no acknowledgment
— refresh-timer seconds
— no refresh-timer
— request-timer request-timer request-timer-secs retry-timer
retry-timer-secs timeout-multiplier multiplier
— [no] description
— [no] egress
— [no] vc-label egress-vc-label
— eth-cfm
— [no] ais-enable
— [no] mep mep-id domain md-index association ma-index
[direction {up | down}]
— [no] ais-enable
— [no] client-meg-level [[level [level ...]]
— [no] interval {1 | 60}{1 | 60}
— [no] priority priority-value
— [no] ccm-enable
— [no] ccm-ltm-priority priority
— [no] description
— [no] eth-test-enable
— [no] bit-error-threshold bit-errors
— [no] test-pattern {all-zeros | all-ones} [crc-
enable]
— [no] fault-propagation-enable {use-if-tlv | suspend-
ccm}
— low-priority-defect {allDef | macRemErrXcon |
remErrXcon | errXcon | xcon | noXcon}
— [no] mac-address mac-address
— [no] one-way-delay-threshold seconds
— [no] shutdown
— mip [mac mac address]
— mip default-mac
— no mip
— [no] force-vlan-vc-forwarding
— [no] ingress
— [no] vc-label egress-vc-label
— precedence [precedence-value| primary]
— no precedence
— [no] pw-path-id
— agi attachment-group-identifier