Network QoS Policies
Quality of Service Guide 103
Default 90% for all classes
Parameters mir — Specifies the percentage of the available link or bundle rate.
Values 1 to 100
weight
Syntax weight weight
no weight
Context config>qos>mc-fr-profile-egress>class
Description This command configures the WRR weight scheduling parameter for each Frame Relay scheduling
class queue for this profile.
Default Class 0=N/A
Class 1=1 (not configurable)
Class 2=89
Class 3=10
Parameters weight — Specifies the weight schedule.
Values 1 to 100
Network QoS Policy Commands
network
Syntax network network-policy-id [create]
no network network-policy-id
Context config>qos
Description This command creates or edits a QoS network policy. The network policy defines the treatment IP or
MPLS packets receive as they ingress and egress the network port.
The QoS network policy consists of an ingress and egress component. The ingress component of the
policy defines how DiffServ code points and MPLS EXP bits are mapped to internal forwarding class
and profile state. The forwarding class and profile state define the Per Hop Behavior (PHB) or the QoS
treatment through the router. The mapping on each network interface defaults to the mappings defined
in the default network QoS policy until an explicit policy is defined for the network interface.
To Next Page
Loading...
