Overview
696 Quality of Service Guide
• Assign a policy ID (policy number). The system will not dynamically assign an ID.
• Include a description. The description provides a brief overview of policy features.
• Configure traffic attributes of the ATM traffic profile.
• Determine whether egress shaping should occur.
The following displays an atm-td-profile policy configuration:
*A:ALA-48>config>qos>atm-td-profile# info
----------------------------------------------
description "TEST ATM TD profile policy"
service-category nrt-vbr
traffic sir 4000 pir 5000
clp-tagging
----------------------------------------------
*A:ALA-48>config>qos>atm-td-profile#
Applying ATM-TD-Profile Policies
Apply ATM QoS traffic descriptor profiles to the following entities:
• ATM VLL (Apipe) SAPs
• Epipe SAPs
• IES SAPs
• Ipipe SAPs
• VPRN SAPs
• VPLS SAPs
ATM VLL (Apipe) SAPs
Use the following CLI syntax to apply ATM QoS traffic descriptor profile policies to Apipe
SAPs on ingress and egress. This command applies only to the 7750 SR and 7950 XRS.
CLI Syntax: config>service>apipe>sap# atm
egress
traffic-desc traffic-desc-profile-id
ingress
traffic-desc traffic-desc-profile-id
To Next Page
Loading...
