Slope QoS Policies
Quality of Service Guide 625
CLI Syntax: config>mcast-mgmt>bw-plcy> mcast-pool percent-of-total
<percent-of-buffers> resv-cbs <percent-of-pool> slope-
policy <policy-name>
Default Slope Policy Values
The default access ingress and egress policies are identified as policy-id 1. The default
policies cannot be edited or deleted. The following displays default policy parameters:
The following output displays the default configuration:
Table 41: Slope Policy Defaults
Field Default
description “Default slope policy”
high-slope
shutdown shutdown
start-avg 70
max-avg 90
max-prob 80
low-slope
shutdown shutdown
start-avg 50
max-avg 75
max-prob 80
exceed-slope
shutdown shutdown
start-avg 30
max-avg 55
max-prob 80
time-average-factor 7
To Next Page
Loading...
