Service SAP QoS Policy Command Reference
370 Quality of Service Guide
mode {native | pool-per-queue} — The mode species whether the WRED per queue is using the
native FP3 WRED capabilities or the FP2 and later hardware pool per queue.
Values native - use the hardware per queue WRED capabilities of the FP3
and requires slope-usage exceed-low.
pool-per-queue - each queue uses its own pool and the WRED
capabilities of the pool to provide WRED per queue. This is
supported on both FP2 and later hardware and requires slope-
usage default.
Default native
slope-usage {default | exceed-low} — This parameter specifies congestion control to be used.
Values default - maps the in, out, and exceed profile traffic to the high,
low, and exceed WRED slopes respectively; this is only supported
for pool-per-queue mode.
exceed-low - maps the out and exceed profile traffic to the low
and exceed WRED slopes with the in profile traffic using the
MBS drop tail. This is only supported for native mode.
Default exceed-low
Show Commands
sap-ingress
Syntax sap-ingress [policy-id] [association | match-criteria | hsmda | detail]
Context show>qos
Description This command displays SAP ingress QoS policy information.
Special Cases Show SAP Ingress Output — The following table describes SAP ingress show command
output.
Note: For consistency across 7950 XRS platforms, C-XMAs/XMAs are modeled in SR OS
(CLI and SNMP) as MDAs.
The command outputs in the following section are examples only; actual displays may differ
depending on supported functionality and user configuration.
Label Description
Policy-Id The ID that uniquely identifies the policy.
Scope Exclusive
Implies that this policy can only be applied to a single SAP.
To Next Page
Loading...
