Slope QoS Policies
Quality of Service Guide 627
MDA (FP1)
The following CLI syntax examples can be used to remove slope policies from MDAs:
CLI Syntax: config>card>mda>access>ingress>pool# no slope-policy
name
config>card>mda>access>egress>pool# no slope-policy name
config>card>mda>network>egress>pool# no slope-policy
name
For the MC Path Mgmt, the mcast-pool can be removed from the bandwidth policy or the
bandwidth-policy can be removed from under the MDA ingress multicast-path-management.
CLI Syntax: config>mcast-mgmt>bw-plcy# no mcast-pool
config>card>mda>ingress>mcast-mgmt# no bandwidth-policy
The following CLI syntax example configures the PPP multilink pool:
CLI Syntax: config>card>mda>access>egress>pool# no slope-policy name
FP (FP2 and higher based hardware)
The following CLI syntax examples can be used to remove slope policies from FP pools:
CLI Syntax: config>card>mda>access>ingress>pool# no slope-policy
name
config>card>mda>access>egress>pool# no slope-policy name
config>card>mda>network>ingress>pool# no slope-policy
name
config>card>mda>network>egress>pool# no slope-policy
name
Although some commands are applied under the MDA CLI tree, the policy is applied to the
FP. If different policies are applied to each MDA, the last policy applied take precedence.
For the MC Path Mgmt, the mcast-pool can be removed from the bandwidth policy or the
bandwidth-policy can be removed from under the FP ingress multicast-path-management.
CLI Syntax: config>mcast-mgmt>bw-plcy# no mcast-pool
config>card>fp>ingress>mcast-mgmt# no bandwidth-policy
To Next Page
Loading...
