Overview
626 Quality of Service Guide
A:ALA-7>config>qos>slope-policy# info detail
----------------------------------------------
description "Default slope policy."
high-slope
shutdown
start-avg 70
max-avg 90
max-prob 80
exit
low-slope
shutdown
start-avg 50
max-avg 75
max-prob 80
exit
exceed-slope
shutdown
start-avg 30
max-avg 55
max-prob 80
exit
time-average-factor 7
----------------------------------------------
A:ALA-7>config>qos>slope-policy#
Deleting QoS Policies
A slope policy is associated by default with XMAs and MDAs and port access and network
egress pools. A default policy may be replaced with a non-default policy, but a policy cannot
be entirely removed from the configuration. When a non-default policy is removed, the policy
association reverts to the default slope policy policy-id default. A QoS policy cannot be
deleted until it is removed from all of the places where it is applied.
A:ALA-7>config>qos# no slope-policy slopePolicy1
MINOR: QOS #1902 Slope policy has references
A:ALA-7>config>qos#
Ports
The following CLI syntax examples can be used to remove slope policies from port pools:
CLI Syntax: config>port>access>ingress>pool# no slope-policy name
config>port>access>egress>pool# no slope-policy name
config>port>network>egress>pool# no slope-policy name
To Next Page
Loading...
