Slope QoS Policy Command Reference
638 Quality of Service Guide
Show Commands
slope-policy
Syntax slope-policy [slope-policy-name] [detail]
Context show>qos
Description This command displays slope policy information.
Parameters slope-policy-name — The name of the slope policy.
detail — Displays detailed information about the slope policy.
Output Slope QoS Policy Output Fields
The following table describes slope QoS policy output fields.
Sample Output
Table 42: Show QoS Slope Policy Output Fields
Label Description
Policy The ID that uniquely identifies the policy.
Description A string that identifies the policy’s context in the configuration file.
Time Avg The weighting between the previous shared buffer average utilization
result and the new shared buffer utilization.
Slope Parameters
Start Avg Specifies the RED slope position for the shared buffer average
utilization value where the packet discard probability starts to increase
above zero.
Max Avg Specifies the percentage of the shared buffer space for the buffer pool
at which point the drop probability becomes 1, expressed as a decimal
integer
Admin State Enabled
The administrative status of the RED slope is enabled.
Disabled
The administrative status of the RED slope is disabled.
Max Prob. Specifies the RED slope position for the maximum non-one packet
discard probability value before the packet discard probability rises
directly to one.
To Next Page
Loading...
