Class Fair Hierarchical Policing (CFHP) Policy Command Reference
874 Quality of Service Guide
Command Descriptions
Configuration Commands
Generic Commands
policer-control-policy
Syntax policer-control-policy policy-name [create]
no policer-control-policy
Context config>qos
Description This command is used to create, delete, or modify policer control policies. The policer-control-policy
controls the aggregate bandwidth available to a set of child policers. Once created, the policy can be
applied to ingress or egress SAPs. The policy can also be applied to the ingress or egress context of a
sub-profile.
Default no policer-control-policy
Parameters policy-name — Each policer-control-policy must be created with a unique policy name. The name
must given as policy-name must adhere to the system policy ASCII naming requirements. If
the defined policy-name already exists, the system will enter that policy’s context for editing
purposes. If policy-name does not exist, the system will attempt to create a policy with the
specified name. Creating a policy may require use of the create parameter when the system is
configured for explicit object creation mode.
Default None
create — The create keyword is required when a new policy is being created and the system is
configured for explicit object creation mode.
description
Syntax description description string
no description
Context config>qos>policer-control-policy
Description The description command is used to define an informational ASCII string associated with the policer
control policy. The string value can be defined or changed at any time once the policy exists.
The no form of this command is used to remove an explicit description string from the policer.
To Next Page
Loading...
