Queue Sharing and Redirection
Quality of Service Guide 419
Adding a Port to a LAG
When adding a port to a LAG group, the port must have the same queue groups defined as
the existing ports on the LAG before it will be allowed as a member. This includes all queue
group override parameters.
Basic Configurations
• Configuring an Ingress Queue Group Template
• Configuring Egress Queue Group Template
• Applying Ingress Queue Group to SAP Ingress Policy
• Applying Egress Queue Group to SAP Egress Policy
• Configuring Queue Group on Ethernet Access Ingress Port
• Configuring Overrides
• Configuring Queue Group on Ethernet Access Egress Port
• Configuring Queue Group for Network Egress Traffic on Port
• Configuring Queue Group for Network Ingress Traffic on Forwarding Plane
• Using Queue Groups to Police Ingress/Egress Traffic on Network Interface
• Configuring Ingress/Egress PW Shaping Using Spoke-SDP Forwarding Class-Based
Redirection
• Specifying QoS Policies on Service SAPs
Configuring an Ingress Queue Group Template
The following displays an ingress queue group template configuration example:
*A:Dut-T>cfg>qos>qgrps# info
----------------------------------------------
ingress
queue-group "QG_ingress_1" create
queue 1 best-effort create
mbs 100
exit
queue 2 best-effort create
mbs 100
exit
queue 3 best-effort create
mbs 100
exit
queue 4 best-effort create
To Next Page