Queue Sharing and Redirection
Quality of Service Guide 423
exit
exit
fc nc create
queue 3 port-redirect-group-queue
hsmda
queue 3 port-redirect-group-queue
exit
exit
----------------------------------------------
This is to be in-conjunction with:
*A:Dut-A# configure service vpls 1
*A:Dut-A>config>service>vpls# info
----------------------------------------------
stp
shutdown
exit
sap 9/1/2:1 create
egress
qos 3 port-redirect-group qg1 instance 101
exit
exit
Configuring Queue Group on Ethernet Access Ingress Port
The provisioning steps involved in using a queue-group queue on an ingress port are:
• Queue Group Template Creation
→ Create the queue group template in the ingress context
→ Create the queue within the queue group template
• Queue Group Creation
→ Identify the ingress port (or ports) for which the queue group will be needed (for
LAG use the primary port member)
→ Create a queue group with the same name as the template on the port or ports
• Map a Forwarding Class to the queue-id within the queue group
→ Map forwarding classes to queue-group queues.
→ Identify or create the SAP ingress QoS policy that will be used on the ingress
SAP where queue redirection is desired
→ Map the desired forwarding classes to the queue group name and the specific
queue ID within the group
• Apply the SAP ingress QoS policy
→ Identify or create the ingress SAP requiring forwarding class redirection to the
queue group
To Next Page
Loading...
