Overview
628 Quality of Service Guide
Remove a Policy from the QoS Configuration
To delete a slope policy, enter the following command:
CLI Syntax: config>qos# no slope-policy policy-id
Example: config>qos# no slope-policy slopePolicy1
Copying and Overwriting QoS Policies
You can copy an existing slope policy, rename it with a new policy ID value, or overwrite an
existing policy ID. The overwrite option must be specified or an error occurs if the destination
policy ID exists.
CLI Syntax: config>qos> copy {slope-policy} source-policy-id dest-
policy-id [overwrite]
The following output displays the copied policies:
A:ALA-7>config>qos# info
---------------------------------------------
...
slope-policy "default" create
description "Default slope policy."
high-slope
shutdown
start-avg 70
max-avg 90
max-prob 80
exit
low-slope
shutdown
start-avg 50
max-avg 75
max-prob 80
exit
exceed-slope
shutdown
start-avg 30
max-avg 55
max-prob 80
exit
time-average-factor 7
exit
slope-policy "slopePolicy1" create
description "Default slope policy."
high-slope
shutdown
start-avg 70
max-avg 90
To Next Page
Loading...
