Service SAP QoS Policy Command Reference
232 Quality of Service Guide
Operational Commands
copy
Syntax copy sap-egress src-pol dst-pol [overwrite]
copy sap-ingress src-pol dst-pol [overwrite]
copy hsmda-pool-policy src-name dst-name [overwrite]
copy hsmda-scheduler-policy src-name dst-name [overwrite]
copy hsmda-slope-policy src-name dst-name [overwrite]
copy named-pool-policy src-name dst-name [overwrite]
Context config>qos
Description This command copies existing QoS policy entries for a QoS policy-id to another QoS policy-id.
The copy command is a configuration level maintenance tool used to create new policies using existing
policies. It also allows bulk modifications to an existing policy with the use of the overwrite keyword.
Parameters sap-egress src-pol dst-pol — Indicates that the source policy ID and the destination policy ID are
sap-egress policy IDs. Specify the source policy ID that the copy command will attempt to
copy from and specify the destination policy ID to which the command will copy a duplicate
of the policy.
Values 1 to 65535
sap-ingress src-pol dst-pol — Indicates that the source policy ID and the destination policy ID
are SAP ingress policy IDs. Specify the source policy ID that the copy command will attempt
to copy from and specify the destination policy ID to which the command will copy a
duplicate of the policy.
Values 1 to 65535
hsmda-pool-policy src-name dst-name — Indicates that the source HSMDA pool policy ID and
the destination policy ID are HSMDA pool policy IDs. Specify the source policy ID that the
copy command will attempt to copy from and specify the destination policy ID to which the
command will copy a duplicate of the policy. This parameter applies only to the 7450 ESS
and 7750 SR.
hsmda-scheduler-policy src-name dst-name — Indicates that the source HSMDA scheduler
policy ID and the destination policy ID are HSMDA scheduler policy IDs. Specify the source
policy ID that the copy command will attempt to copy from and specify the destination policy
ID to which the command will copy a duplicate of the policy. This parameter applies only to
the 7450 ESS and 7750 SR.
hsmda-slope-policy src-name dst-name — Indicates that the source HSMDA slope policy ID
and the destination policy ID are HSMDA slope policy IDs. Specify the source policy ID that
the copy command will attempt to copy from and specify the destination policy ID to which
the command will copy a duplicate of the policy. This parameter applies only to the 7450 ESS
and 7750 SR.
To Next Page
Loading...
