Alcatel-Lucent 7450 - VLAN ID Matching

Service Egress and Ingress QoS Policies
Quality of Service Guide 213
• Match criteria for ingress SAP QoS policy. Optionally, specify an IP protocol to be
used as an ingress SAP QoS policy match criterion.
The following displays an ingress MAC criteria configuration:
A:ALA-7>config>qos# info
...
#------------------------------------------
echo "QoS Policy Configuration"
#------------------------------------------
...
sap-ingress 101 create
...
mac-criteria
entry 10 create
description "Entry10-low prio"
match
dst-mac 04-67-ff-00-00-01 ff-ff-ff-ff-ff-ff
dot1p 7 7
exit
action fc be priority low
exit
exit
exit
#------------------------------------------
A:ALA-7>config>qos#
VLAN ID Matching
On ingress VLAN ID matching may be used to set QoS on SAP ingress. The matching rules
are the same as for VID filter (See “VID filters” in the Filter Policies section of the Router
Configuration Guide) but the action allows setting of the forwarding class.
For example, to set the forwarding class of all VIDs with 6 in the lower 3 bits of the VID a
filter as illustrated below could be constructed and then ingress qos 5 could be applied to any
SAP that requires the policy.
qos
sap-ingress 5 create
queue 1 create
exit
queue 11 multipoint create
exit
mac-criteria
type vid
entry 1 create
match frame-type ethernet-II
outer-tag 6 7
exit
action fc "af"
exit
exit