QoS Queue Group Template Command Reference
500 Quality of Service Guide
Monitor Commands
card
Syntax card slot-number fp fp-number ingress {access | network} queue-group queue-group-
name instance instance-id [interval seconds] [repeat repeat] policer policer-id [absolute |
percent-rate | reference-rate]
Context monitor
Description This command monitors policer statistics in an ingress FP queue group.
Parameters card slot-number — Specifies the slot number associated with the queue group, expressed as an
integer.
Values 1 to 20
fp fp-number — Specifies the FP number associated with the queue group, expressed as an
integer.
Values 1 to 2
ingress — Displays policer statistics applied on the ingress FP.
access — Displays policer statistics on the FP access.
network — Displays policer statistics on the FP network.
queue-group queue-group-name — Specifies the name of the queue group up to 32 characters
in length
instance instance-id — Specifies the identification of a specific instance of the queue-group.
Values 1 to 65535
interval seconds — Configures the interval for each display in seconds.
Default 11 seconds
Values 11 to 60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 to 999
policer policer-id — The specified policer-id must exist within the queue-group template applied
to the ingress context of the forwarding plane.
Values
1 to 32
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
processing. No calculations are performed on the delta or rate statistics.
percent-rate — When the percent-rate keyword is specified, the rate-per-second for each statistic
is displayed based on the reference rate of 10G.
To Next Page