Named Pools
Quality of Service Guide 723
Ingress Q1 Named Pools 0 0 0
Egress Q1 Named Pools 0 0 0
*A:PE#
Basic Configuration
A basic named pool QoS policy must conform to the following:
• Default values can be modified but parameters cannot be deleted.
Create a Named Pool QoS Policy
To create a new named pool policy, the following must be defined:
• A named pool policy ID value. The system will not dynamically assign a value.
Named pool Configuration Procedure
Step 1: Configure the named pool policy.
CLI Syntax: config# configure qos named-pool-policy 3pools create
q1-pools
pool p1 create
exit
pool p2 create
exit
pool p3 create
exit
exit all
Step 2: Apply the named pool policy on ingress and/or egress XMA or MDA and/or port.
Since the named pool mode is not yet active on the card, all queues are drawing buffer from
the default pool.
Queue to named pool association.
Configure the queues to get buffers from a named pool.
Configure the named pool policy.
To Next Page
Loading...
