Overview
724 Quality of Service Guide
CLI Syntax: config# network queue
configure qos
copy network-queue default 15
network-queue 15
queue 1 pool p1
exit all
Step 3: Configure the above queue profile to be used by the respective applications or port.
Configure the named pool policy.
CLI Syntax: config# configure card 1 mda 2 network ingress queue-
policy 15
Step 4: Turn on named pool on the card. The card will reboot and the named pool mode will
be active on the card.
CLI Syntax: configure card 1 named-pool-mode now
To check the pools after named pool mode was enabled, use “show pools mda”. There are no
port pools unless a port has configured a named pool policy. Only named pools that have
active queues associated will be shown with a non-zero size; this means that the named pool
was created. If a named pool is configured but has no active queue associated, the size of the
pool is zero. The named pool would be instantiated but not created. An example is shown
below.
Example:
A:SR7-10# show pools 1/2
===============================================================================
===============================================================================
Type Id App. Pool Name Actual ResvCBS PoolSize
Admin ResvCBS
-------------------------------------------------------------------------------
MDA 1/2 Acc-Ing default 3072 10240
Sum
MDA 1/2 Acc-Ing MC Path Mgmt 0 0
50%
MDA 1/2 Acc-Egr default 12288 40960
Sum
MDA 1/2 Net-Ing default 20480 40960
Sum
MDA 1/2 Net-Egr default 81920 163840
Sum
MDA 1/2 Ingress p1 12288 28672
Policy: 3pools 30%
MDA 1/2 Ingress p2 0 0
Policy: 3pools 30%
MDA 1/2 Ingress p3 0 0
Policy: 3pools 30%
===============================================================================
To Next Page
Loading...
