Service Egress and Ingress QoS Policies
Quality of Service Guide 199
Figure 13: Egress SAP
The configuration would be as follows:
sap-egress 10 create
queue 1 create
exit
policer 1 create
exit
ip-criteria
entry 10 create
match
dscp ef
exit
action policer 1
exit
exit
exit
Dot1p Egress Remarking
Dot1p marking can be performed on egress for all services and with respect to the profile of
the packet and the VLAN tag.
The following commands can be used to remark the dot1p values at a SAP egress:
CLI Syntax: sap-egress policy-id create
fc fc-name create
dot1p {dot1p-value | in-profile dot1p-value out-
profile dot1p-value [exceed-profile dot1p-value]}
dot1p-inner {dot1p-value | in-profile dot1p-value
out-profile dot1p-value}
dot1p-outer {dot1p-value | in-profile dot1p-value
out-profile dot1p-value [exceed-profile dot1p-
value]}
al_0617
DSCP EF Traffic
Other Traffic
FC=BE
Policer 1
queue 1
policer-output-queues
queue-group
To Next Page
Loading...
