Overview
624 Quality of Service Guide
Ports
The following CLI syntax examples may be used to apply slope policies to port pools:
CLI Syntax: config>port>access>ingress>pool>slope-policy name
config>port>access>egress>pool>slope-policy name
config>port>network>egress>pool>slope-policy name
MDA (FP1)
The following CLI syntax examples may be used to apply slope policies to MDA pools:
CLI Syntax: config>card>mda>access>ingress>pool>slope-policy name
config>card>mda>access>egress>pool>slope-policy name
config>card>mda>network>egress>pool>slope-policy name
For the MC Path Mgmt, the slope policy is configured within a multicast management
bandwidth policy which is then applied under the MDA ingress multicast-path-management.
CLI Syntax: config>mcast-mgmt>bw-plcy> mcast-pool percent-of-total
<percent-of-buffers> resv-cbs <percent-of-pool> slope-
policy <policy-name>
config>card>mda>ingress>mcast-mgmt# bandwidth-policy
<policy-name>
The following CLI syntax example configures the PPP multilink pool:
CLI Syntax: config>card>mda>access>egress>pool>slope-policy name
FP (FP2 and higher based hardware)
The following CLI syntax examples may be used to apply slope policies to FP pools:
CLI Syntax: config>card>mda>access>ingress>pool>slope-policy name
config>card>mda>access>egress>pool>slope-policy name
config>card>mda>network>ingress>pool>slope-policy name
config>card>mda>network>egress>pool>slope-policy name
Although these commands are applied under the MDA CLI tree, the policy is applied to the
FP. If different policies are applied to each MDA, the last policy applied take precedence.
For the MC Path Mgmt, the slope policy is configured within a multicast management
bandwidth policy which is then applied under the FP ingress multicast-path-management.
To Next Page
Loading...
