Alcatel-Lucent 7450 - Page 696

Overview
698 Quality of Service Guide
VPLS SAPs
Use the following CLI syntax to apply ATM QoS traffic descriptor profile policies to VPLS
SAPs on ingress and egress.
CLI Syntax: config>service>vpls>sap# atm
egress
traffic-desc traffic-desc-profile-id
ingress
traffic-desc traffic-desc-profile-id
Default ATM-TD-Profile Policy Values
The default ATM QoS traffic descriptor profile is identified as default. The default profile
cannot be edited or deleted. The following displays default profile parameters:
The following output displays the default configuration:
A:ALA-48>config>qos# info detail
...
#------------------------------------------
echo "QoS Slope/Queue Policies Configuration"
#------------------------------------------
atm-td-profile 1 create
description "Default Traffic Descriptor"
service-category ubr
no traffic
no policing
no clp-tagging
Table 49: ATM-TD-Profile Defaults
Field Default
atm-td-profile traffic-desc-profile-id 1
description “Default Traffic Descriptor”
service-category ubr
traffic no traffic
policing no policing
clp-tagging no clp-tagging
descriptor-type P0_1
shaping no shaping