Network QoS Policy Command Reference
106 Quality of Service Guide
The classification only applies to the outer IP header of non-tunneled traffic. The only exception is for
traffic received on a Draft Rosen tunnel for which classification on the outer IP header only is
supported.
Attempting to apply a network QoS policy containing an ip-criteria statement to any object except a
network IP interface will result in an error.
The no form of this command deletes all the entries specified under this node. Once IP criteria entries
are removed from a network ingress policy, the IP criteria is removed from all network interfaces
where that policy is applied. This command is supported on FP2 and higher based hardware and is
otherwise ignored.
ipv6-criteria
Syntax [no] ipv6-criteria
Context config>qos>network>ingress
Description IP criteria-based network ingress policies are used to select the appropriate ingress queue and
corresponding forwarding class for matched traffic. This command is used to enter the context to create
or edit policy entries that specify IPv6 criteria such as IP quintuple lookup or DiffServ code point.
The 7750 SR OS implementation will exit on the first match found and execute the actions in
accordance with the accompanying action command. For this reason, entries must be sequenced
correctly from most to least explicit.
The classification only applies to the outer IPv6 header of non-tunneled traffic.
Attempting to apply a network QoS policy containing an ipv6-criteria statement to any object except
a network IP interface will result in an error.
The no form of this command deletes all the entries specified under this node. Once IP criteria entries
are removed from a network ingress policy, the IP criteria is removed from all network interfaces
where that policy is applied.
This command is supported on FP2 and higher based hardware and is otherwise ignored.
action
Syntax action [fc fc-name] [profile {in | out}]
no action
Context config>qos>network>ingress>ip-criteria>entry
config>qos>network>ingress>ipv6-criteria>entry
Description This mandatory command associates the forwarding class and packet profile with specific IP or IPv6
criteria entry ID.
To Next Page
Loading...
