Alcatel-Lucent 7450 - Page 112

Network QoS Policy Command Reference
112 Quality of Service Guide
The no form of this command removes the destination IP address match criterion.
Parameters ip-address — The IP address of the destination IP or IPv6 interface. This address must be unique
within the subnet and specified in dotted decimal notation.
Values
dst-port
Syntax dst-port {lt | gt | eq} dst-port-number
dst-port range start end
no dst-port
Context config>qos>network>ingress>ip-criteria>entry>match
config>qos>network>ingress>ipv6-criteria>entry>match
Description This command configures a destination TCP or UDP port number or port range for a network ingress
QoS policy match criterion.
The no form of this command removes the destination port match criterion.
Default none
Parameters lt | gt | eq dst-port-number — The TCP or UDP port numbers to match specified as less than (lt),
greater than (gt) or equal to (eq) to the destination port value specified as a decimal integer.
Values 1 to 65535 (decimal)
range start end — The range of TCP or UDP port values to match specified as between the start
and end destination port values inclusive.
Values 1 to 65535 (decimal)
fragment
Syntax fragment {true | false}
no fragment
Context config>qos>ingress>ip-criteria>entry>match
Description This command configures fragmented or non-fragmented IP packets as a network ingress QoS policy
match criterion.
ip-address: a.b.c.d
ipv6-address: x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x: [0 to FFFF]H
d: [0 to 255]D
prefix-length: 1 to 128