Alcatel-Lucent 7450 - Page 114

Network QoS Policy Command Reference
114 Quality of Service Guide
Default No source IP match criterion.
Parameters ip-address — Specifies the source IPv4 address specified in dotted decimal notation.
Values ip-address: a.b.c.d
mask — Specifies the length in bits of the subnet mask.
Values 1 to 32
ipv4-address-mask — Specifies the subnet mask in dotted decimal notation.
Values a.b.c.d (dotted quad equivalent of mask length)
ipv6-address — Specifies the IPv6 prefix for the IP match criterion in hex digits.
Values ipv6-address: x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x: [0 to FFFF]H
d: [0 to 255]D
prefix — Specifies the IPv6 prefix length for the ipv6-address expressed as a decimal integer.
Values 1 to 128
mask — Specifies the eight 16-bit hexadecimal pieces representing bit match criteria.
Values x:x:x:x:x:x:x (eight 16-bit pieces)
src-port
Syntax src-port {lt | gt | eq} src-port-number
src-port range start end
Context config>qos>network>ingress>ip-criteria>entry>match
config>qos>network>ingress>ipv6-criteria>entry>match
Description This command configures a source TCP or UDP port number or port range for a network ingress QoS
policy match criterion.
The no form of this command removes the source port match criterion.
Default No src-port match criterion.
Parameters lt | gt | eq src-port-number — The TCP or UDP port numbers to match specified as less than (lt),
greater than (gt) or equal to (eq) to the source port value specified as a decimal integer.
Values 1 to 65535 (decimal)
range start end — The range of TCP or UDP port values to match specified as between the start
and end source port values inclusive.
Values 1 to 65535 (decimal)