Network QoS Policies
Quality of Service Guide 125
Default
Parameters dscp-name — System- or user-defined, case-sensitive dscp-name.
Default none
Values Any defined system- or user-defined dscp-name
lsp-exp-in-profile
Syntax lsp-exp-in-profile lsp-exp-value
no lsp-exp-in-profile
Context config>qos>network>egress>fc
Description This command specifies the in-profile LSP EXP value for the forwarding class. The EXP value will
be used for all LSP labeled packets requiring marking the egress on this forwarding class queue that
are in-profile.
When multiple EXP values are associated with the forwarding class at network egress, the last name
entered will overwrite the previous value.
The no form of this command reverts to the factory default in-profile EXP setting.
Default
Parameters lsp-exp-value — The 3-bit LSP EXP bit value, expressed as a decimal integer.
Default none
Values 0 to 7
lsp-exp-out-profile
Syntax lsp-exp-out-profile lsp-exp-value
no lsp-exp-out-profile
Context config>qos>network>egress>fc
Description This command specifies the out-of-profile LSP EXP value for the forwarding class. The EXP value
will be used for all LSP labeled packets requiring marking the egress on this forwarding class queue
that are out-of-profile. The exceed-profile traffic is marked with the same value as out-of-profile
traffic.
Policy-id 1: Factory setting
Policy-id 2 to 65535: Policy-id setting
Policy-id 1: Factory setting
Policy-id 2 to 65535: Policy-id setting
To Next Page
Loading...
