Network QoS Policy Command Reference
132 Quality of Service Guide
bgp, cflowd, dhcp, diameter, dns, ftp, gtp, icmp, igmp, igmp-
reporter, l2tp, ldp, mld, msdp, ndis, ntp, ospf, pcep, pim, ptp,
radius, rip, rsvp, sflow, snmp, snmp-notification, srrp, ssh, syslog,
tacplus, telnet, tftp, traceroute, vrrp
Values The following values apply to the 7450 ESS:
bgp, dhcp, dns, ftp, icmp, igmp, ldp, mld, ntp, ospf, radius, rsvp,
rip, ssh, snmp, snmp-notification, syslog, telnet, tftp, traceroute,
tacplus, vrrp
dscp-value — Specifies a value when this packet egresses the respective egress policy should
provide the mapping for the DSCP value to either LSP-EXP bits or IEEE 802.1p (Dot1P) bits
as appropriate otherwise the default mapping applies.
Values 0 to 63
dscp-name — Specifies the DSCP name.
Values none, be, ef, cp1, cp2, cp3, cp4, cp5, cp6, cp7, cp9, cs1, cs2, cs3,
cs4, cs5, nc1, nc2, af11, af12, af13, af21, af22, af23, af31, af32,
af33, af41, af42, af43, cp11, cp13, cp15, cp17, cp19, cp21, cp23,
cp25, cp27, cp29, cp31, cp33, cp35, cp37, cp39, cp41, cp42, cp43,
cp44, cp45, cp47, cp49, cp50, cp51, cp52, cp53, cp54, cp55, cp57,
cp58, cp59, cp60, cp61, cp62, cp63
dot1p-priority — Specifies the Dot1P priority.
Values 0 to 7
dot1p-app-name — Specifies the Dot1P application name.
Values The following values apply to the 7750 SR and 7950 XRS:
arp, isis, pppoe
Values The following values apply to the 7450 ESS
arp, isis
dscp
Syntax dscp dscp-name fc fc-name
no dscp dscp-name
Context config>router>sgt-qos
config>service>vprn>sgt-qos
Description This command creates a mapping between the DiffServ Code Point (DSCP) of the self generated
traffic and the forwarding class.
Self generated traffic that matches the specified DSCP will be assigned to the corresponding
forwarding class. Multiple commands can be entered to define the association of some or all sixty-four
DiffServ code points to the forwarding class.
All dscp name that defines a dscp value must be explicitly defined
To Next Page
Loading...
