Network QoS Policies
Quality of Service Guide 145
sgt-qos
Syntax sgt-qos
Context show>router
Description This command displays QoS information for self-generated traffic. In the output, “none” means that
the default values for each application are used, not that there is no value set. For a list of application
defaults, see QoS for Self-Generated (CPU) Traffic on Network Interfaces and Table 18.
application
Syntax application [app-name] [dscp | dot1p]
Context show>router>sgt-qos
Description This command displays application QoS settings.
Parameters app-name — The specific application.
Values The following values apply to the 7750 SR and 7950 XRS:
arp, bgp, cflowd, dhcp, diameter, dns, ftp, gtp, icmp, igmp, igmp-
reporter, isis, l2tp, ldp, mld, msdp, ndis, ntp, ospf, pcep, pim,
pppoe, ptp, radius, rip, rsvp, sflow, snmp, snmp-notification, srrp,
ssh, syslog, tacplus, telnet, tftp, traceroute, vrrp
Values The following values apply to the 7450 ESS:
arp, bgp, dhcp, dns, ftp, icmp, isis, ldp, ntp, ospf, radius, rip, rsvp,
snmp, snmp-notification, ssh, syslog, tacplus, telnet, tftp,
traceroute, vrrp
dscp-map
Syntax dscp-map [dscp-name]
Context show>router>sgt-qos
Description This command displays DSCP to FC mappings.
Parameters dscp-name — The specific DSCP name.
be, ef, cp1, cp2, cp3, cp4, cp5, cp6, cp7, cp9, cs1, cs2, cs3, cs4, cs5, nc1, nc2, af11, af12, af13,
af21, af22, af23, af31, af32, af33, af41, af42, af43, cp11, cp13, cp15, cp17, cp19, cp21, cp23,
cp25, cp27, cp29, cp31, cp33, cp35, cp37, cp39, cp41, cp42, cp43, cp44, cp45, cp47, cp49,
cp50, cp51, cp52, cp53, cp54, cp55, cp57, cp58, cp59, cp60, cp61, cp62, cp63
To Next Page
Loading...
