Network Queue QoS Policy Command Reference
164 Quality of Service Guide
Network Queue QoS Policy Commands
network-queue
Syntax [no] network-queue policy-name
Context config>qos
Description This command creates a context to configure a network queue policy. Network queue policies define
the ingress network queuing at the XMA or MDA network node level and on the Ethernet port and
SONET/SDH path level to define network egress queuing.
Default default
Parameters policy-name — The name of the network queue policy.
Values Valid names consist of any string up to 32 characters long
composed of printable, 7-bit ASCII characters. If the string
contains special characters (#, $, spaces, etc.), the entire string
must be enclosed within double quotes.
fc
Syntax [no] fc fc-name
Context config>qos>network-queue
Description The fc context in the network-queue context provides a forwarding class queue context to the
contained buffer control and queue rate commands.
The fc node contains the PIR, CIR, CBS and MBS commands used to control the buffer pool resources
of each forwarding class queue on the ingress and egress pools that are associated with the network-
queue policy.
The no form of this command restores all PIR, CIR, CBS and MBS parameters for the forwarding class
network queue to their default values.
Parameters fc-name — The forwarding class name for which the contained PIR, CIR, CBS and MBS queue
attributes apply. An instance of fc is allowed for each fc-name.
Values be, l2, af, l1, h2, ef, h1, nc
multicast-queue
Syntax multicast-queue queue-id
no multicast-queue
Context config>qos>network-queue>fc
To Next Page
Loading...
