Service SAP QoS Policy Command Reference
282 Quality of Service Guide
pool-name — The specified pool-name identifies a named pool where the policy will be applied.
Each queue created within the system is tied to a physical port. When the policy is applied
and the queue is created, the system will scan the named pools associated with the port to find
the specified pool name. If the pool is not found on the port, the system will then look at
named pools defined at the ports MDA level. If the pool name is not found on either the port
or MDA, the queue will be marked as ‘pool-orphaned’ and will be mapped to the appropriate
default pool. If the pool comes into existence, the queue will be moved from the default pool
to the new named pool and the ‘pool-orphaned’ state will be cleared. The specified name must
be an ASCII name string up to 16 characters long.
Values Any valid ASCII name string
Default None
The queue’s pool association may only be removed by either re-executing the queue
command without the pool keyword or by executing the no pool command within the queue’s
CLI context. When the pool name is removed, the queue will be placed on the appropriate
default pool.
Service Ingress QoS Policy Forwarding Class Commands
broadcast-queue
Syntax broadcast-queue queue-id [group queue-group-name]
Context config>qos>sap-ingress>fc
Description This command overrides the default broadcast forwarding type queue mapping for fc fc-name. The
specified queue-id must exist within the policy as a multipoint queue before the mapping can be made.
Once the forwarding class mapping is executed, all broadcast traffic on a SAP using this policy will be
forwarded using the queue-id.
The broadcast forwarding type usually tracks the multicast forwarding type definition. This command
overrides that default behavior.
The no form of the command sets the broadcast forwarding type queue-id back to the default of
tracking the multicast forwarding type queue mapping.
Parameters queue-id — The queue-id parameter must be an existing, multipoint queue defined in the
config>qos>sap-ingress context.
Values Any valid multipoint queue ID in the policy including 2 through
32.
Default 11
To Next Page
Loading...
