Service Egress and Ingress QoS Policies
Quality of Service Guide 285
The no form of the command disables ingress remarking of in-profile packets classified to the
forwarding class or sub-class.
Parameters dscp dscp-name — This parameter is one of two mutually exclusive settings that are applicable
to the in-remark command. The in-remark command can be configured to either remark the
DiffServ Code Point (DSCP) six bit value or the three Precedence bits. The dscp parameter
specifies that the matching packets DSCP bits should be overridden with the value
represented by dscp-name.
32 characters, maximum, The name specified by dscp-name is used to refer to the six bit value
represented by dscp-name. It must be one of the predefined DSCP names defined on the
system.
Values be, cp1, cp2, cp3, cp4, cp5, cp6, cp7, cs1, cp9, af11, cp11, af12,
cp13, af13, cp15, cs2, cp17, af21, cp19, af22, cp21, af23, cp23,
cs3, cp25, af31, cp27, af32, cp29, af33, cp31, cs4, cp33, af41, c
p35, af42, cp37, af43, cp39, cs5, cp41, cp42, cp43, cp44, cp45, ef,
cp47, nc1, cp49, cp50, cp51, cp52, cp53, cp54, cp55, nc2, cp57,
cp58, cp59, cp60, cp61, cp62, cp63
Default None (an explicit valid DSCP name must be specified)
prec ip-prec-value — This parameter is one of two mutually exclusive settings that are applicable
to the in-remark command. The in-remark command can be configured to either remark the
DiffServ Code Point (DSCP) six bit value or the three Precedence bits. The prec parameter
specifies that the matching packets Precedence bits should be overridden with the value
represented by prec-value.
Values 0 to 7
Default None (an explicit precedence value must be specified)
multicast-queue
Syntax multicast-queue queue-id [group queue-group-name]
Context config>qos>sap-ingress>fc
Description This command overrides the default multicast forwarding type queue mapping for fc fc-name. The
specified queue-id must exist within the policy as a multipoint queue before the mapping can be made.
Once the forwarding class mapping is executed, all multicast traffic on a SAP using this policy is
forwarded using the queue-id.
Non-Routed, Explicit Out-of-Profile No Effect (non-routed packet)
IP Routed, Policed In-Profile in-remark value applied to IP header ToS field
IP Routed, Policed Out-of-Profile No Effect (out-of-profile packet)
IP Routed, Explicit In-Profile in-remark value applied to IP header ToS field
IP Routed, Explicit Out-of-Profile No Effect (out-of-profile packet)
SAP Ingress Packet State ‘in-remark’ Command Effect
To Next Page
Loading...
