Service SAP QoS Policy Command Reference
294 Quality of Service Guide
Description This command assigns the low burst maximum class to associate with the HSMDA queue.
The no form of the command returns the class id for the queue to the default value.
Parameters class-id — Specifies the class identifier of the low burst max class for the HSMDA queue.
Values 1 to 32
wrr-weight
Syntax wrr-weight value
no wrr-weight
Context config>qos>sap-egress>hsmda-queues>queue
Description This command assigns the weight value to the HSMDA queue.
The no form of the command returns the weight value for the queue to the default value.
Parameters value — Specifies the weight for the HSMDA queue.
Values 1 to 32
slope-policy
Syntax slope-policy hsmda-slope-policy-name
no slope-policy
Context config>qos>sap-egress>hsmda-queues>queue
Description This command associates an existing HSMDA slope policy to the QoS policy HSMDA queue. The
specified hsmda-slope-policy-name must exist for the command to succeed. If the policy name does
not exist, the command has no effect on the existing slope policy association. Once a slope policy is
associated with a QoS policy queue, subscriber profile override or SAP override, the slope policy
cannot be removed from the system. Any edits to an associated slope policy are immediately applied
to the queues using the slope policy.
Within the ingress and egress QoS policies, packets are classified as high priority or low-priority. For
color aware policies, packets are also potentially classified as in-profile, out-of-profile or profile-
undefined. Based on these classifications, packets are mapped to the RED slopes in the following
manner:
Ingress Slope Mapping
• In-Profile — High Slope (priority ignored)
• Profile-Undefined, High Priority — High Slope
• Out-of-Profile Low Slope (priority ignored)
• Profile-Undefined, Low Priority — Low Slope
To Next Page
Loading...
