Service Egress and Ingress QoS Policies
Quality of Service Guide 301
The list of flow criteria is evaluated in a top down fashion with the lowest entry ID at the top and the
highest entry ID at the bottom. If the defined match criteria for an entry within the list matches the
information in the egress packet, the system stops matching the packet against the list and performs the
matching entries reclassification actions. If none of the entries match the packet, the IP flow
reclassification list has no effect on the packet.
An entry is not populated in the list unless the action command is executed for the entry. An entry that
is not populated in the list has no effect on egress packets. If the action command is executed without
any explicit reclassification actions specified, the entry is populated in the list allowing packets
matching the entry to exit the list, preventing them from matching entries lower in the list. Since this
is the only flow reclassification entry that the packet matched and this entry explicitly states that no
reclassification action is to be performed, the matching packet will not be reclassified.
The no form of this command removes the specified entry from the policy. Entries removed from the
policy are immediately removed from all services where that policy is applied.
Default none
Parameters entry-id — The entry-id, expressed as an integer, uniquely identifies a match criterion and the
corresponding action. It is recommended that multiple entries be given entry-ids in staggered
increments. This allows users to insert a new entry in an existing policy without requiring
renumbering of all the existing entries.
An entry cannot have any match criteria defined (in which case, everything matches) but must
have at least the keyword action fc fc-name for it to be considered complete. Entries without
the action keyword will be considered incomplete and hence will be rendered inactive.
Default none
Values 1 to 65535
create — Required parameter when creating a flow entry when the system is configured to require
the explicit use of the keyword to prevent accidental object creation. Objects may be
accidentally created when this protection is disabled and an object name is mistyped when
attempting to edit the object. This keyword is not required when the protection is disabled.
The keyword is ignored when the flow entry already exists.
match
Syntax [no] match [protocol protocol-id]
Context config>qos>sap-egress>ip-criteria>entry
config>qos>sap-ingress>ip-criteria>entry
Description This command creates a context to configure match criteria for SAP QoS policy match criteria. When
the match criteria have been satisfied the action associated with the match criteria is executed.
If more than one match criteria (within one match statement) are configured, then all criteria must be
satisfied (AND function) before the action associated with the match is executed.
To Next Page
Loading...
