Service SAP QoS Policy Command Reference
306 Quality of Service Guide
It is strongly recommended that the user does not enable cell-concatenation on the spoke-SDP when a
VCI QoS filter is applied to the SAP. The filter will match against the VCI in the header of the first
cell in the concatenated packet. Cell concatenation is disabled by default on a spoke-sdp of all ATM
VLL service types.
The no form of this command removes the VCI value as the match criterion.
Parameters vci-value — The value of the VCI field in the received ATM cell header.
Values 1, 2, 5 to 65535
IP QoS Policy Match Commands
dscp
Syntax dscp
no dscp
Context config>qos>sap-ingress>ip-criteria>entry>match
config>qos>sap-egress>ip-criteria>entry>match
config>qos>sap-ingress>ipv6-criteria>entry>match
config>qos>sap-egress>ipv6-criteria>entry>match
Description This command configures a DiffServ Code Point (DSCP) code point to be used as a SAP QOS policy
match criterion.
The no form of this command removes the DSCP match criterion.
Default none
Parameters dscp-name — Specifies a dscp name that has been previously mapped to a value using the dscp-
name command. The DiffServ code point can only be specified by its name.
Values be, cp1, cp2, cp3, cp4, cp5, cp6, cp7, cs1, cp9, af11, cp11, af12,
cp13, af13, cp15, cs2, cp17, af21, cp19, af22, cp21, af23, cp23,
cs3, cp25, af31, cp27, af32, cp29, af33, cp31, cs4, cp33, af41, c
p35, af42, cp37, af43, cp39, cs5, cp41, cp42, cp43, cp44, cp45, ef,
cp47, nc1, cp49, cp50, cp51, cp52, cp53, cp54, cp55, nc2, cp57,
cp58, cp59, cp60, cp61, cp62, cp63
hsmda
Syntax hsmda
Context config>qos>sap-egress>fc
To Next Page
Loading...
