Service SAP QoS Policy Command Reference
310 Quality of Service Guide
To match on the IPv4 or IPv6 destination address, specify the address and its associated mask, e.g.,
10.1.0.0/16. The conventional notation of 10.1.0.0 255.255.0.0 can also be used for IPv4.
The no form of this command removes the destination IPv4 or IPv6 address match criterion.
Default No destination IP match criteria
Parameters ip-address — Specifies the destination IPv4 address specified in dotted decimal notation.
Values ip-address: a.b.c.d
mask — Specify the length in bits of the subnet mask.
Values 1 to 32
ipv4-address-mask — Specify the subnet mask in dotted decimal notation.
Values a.b.c.d (dotted quad equivalent of mask length)
ip-prefix-list — creates a list of IPv4 prefixes for match criteria in QoS policies. An ip-prefix-list
must contain only IPv4 address prefixes.
prefix-list-name — A string of up to 32 characters of printable ASCII characters. If special
characters are used, the string must be enclosed within double quotes.
ipv6-address — The IPv6 prefix for the IP match criterion in hex digits (applies to the 7750 SR
and 7950 XRS).
Values ipv6-address x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x::d.d.d.d
x: [0 to FFFF]H
d: [0 to 255]D
prefix-length — The IPv6 prefix length for the ipv6-address expressed as a decimal integer
(applies to the 7750 SR and 7950 XRS).
Values 1 to 128
mask — Eight 16-bit hexadecimal pieces representing bit match criteria.
Values x:x:x:x:x:x:x (eight 16-bit pieces)
dst-port
Syntax dst-port {lt | gt | eq} dst-port-number
dst-port range start end
no dst-port
Context config>qos>sap-ingress
config>qos>sap-ingress>ip-criteria>entry>match
config>qos>sap-egress>ip-criteria>entry>match
config>qos>sap-ingress>ipv6-criteria>entry>match
config>qos>sap-egress>ipv6-criteria>entry>match
To Next Page
Loading...
