Service SAP QoS Policy Command Reference
342 Quality of Service Guide
Parameters policy-id — The policy-id uniquely identifies the policy on the router.
Default none
Values 1 to 65535
policy-name — The policy-name uniquely identifies the policy.
Values Valid names consist of any string up to 64 characters long.
Policies must first be created with a policy-id, after which a
policy-name can be assigned and used as an alias to reference the
policy during configuration changes. Policy names may not begin
with a number (0-9) or the underscore “_” character (e.g.
_myPolicy). “default” can not be used as policy names. Saved
configurations and display output from the "info" and most
"show" commands will show the policy-id (not the policy-name)
where the policies are referenced.
de-mark
Syntax [no] de-mark [force de-value]
Context config>qos>sap-egress>fc
Description This command is used to explicitly define the marking of the DE bit for fc fc-name according to the
in-profile, out-of-profile, or exceed-profile status of the packet (fc-name may be used to identify the
dot1p-value).
If no de-value is present, the default values are used for the marking of the DE bit: for example, 0 for
in-profile packets, 1 for out-of-profile or exceed-profile packets– see IEEE 802.1ad-2005 standard.
In the PBB case, for a Backbone SAP (B-SAP) and for packets originated from a local I-VPLS/PBB-
Epipe, the command dictates the marking of the DE bit for both the BVID and ITAG.
If this command is not used, the DE bit should be preserved if an ingress TAG exist or set to zero
otherwise.
If the de-value is specifically mentioned in the command line it means this value is to be used for all
the packets of this forwarding class regardless of their in/out of profile status.
The commands de-mark-inner and de-mark-outer take precedence over the de-mark command if
both are specified in the same policy.
Values: 0 or 1
dot1p
Syntax [no] dot1p {dot1p-value | in-profile dot1p-value out-profile dot1p-value [exceed-profile
dot1p-value]}
To Next Page
Loading...
