Service SAP QoS Policy Command Reference
354 Quality of Service Guide
size — When a numeric value is specified (size), the system interprets the value as an explicit burst
limit size. The value is expressed as an integer and by default is interpreted as the burst limit
in Kilobytes. If the value is intended to be interpreted in bytes, the byte qualifier must be
added following size.
Values 1 to 13,671 kilobites or 14,000,000 bytes
Default No default for size, use the default keyword to specify default
burst limit
bytes — The bytes qualifier is used to specify that the value given for size must be interpreted as
the burst limit in bytes. The byte qualifier is optional and mutually exclusive with the
kilobytes qualifier.
kilobytes — The kilobyte qualifier is used to specify that the value given for size must be
interpreted as the burst limit in Kilobytes. The kilobyte qualifier is optional and mutually
exclusive with the bytes qualifier. If neither bytes nor kilobytes is specified, the default
qualifier is kilobytes.
burst-limit
Syntax burst-limit size [bytes | kilobytes]
no burst-limit
Context config>qos>sap-egress>hsmda-queue>queue
Description The queue burst-limit command is used to define an explicit shaping burst size for a queue. The
configured size defines the shaping leaky bucket threshold level that indicates the maximum burst over
the queue’s shaping rate.
The burst-limit command is supported under the sap-ingress and sap-egress QoS policy queues. The
command is also supported under the ingress and egress queue-group-templates queues.
The no form of this command is used to restore the default burst limit to the specified queue. This is
equivalent to specifying burst-limit default within the QoS policies or queue group templates. When
specified within a queue-override queue context, any current burst limit override for the queue will be
removed and the queue’s burst limit will be controlled by its defining policy or template.
Default no burst-limit
Parameters size — When a numeric value is specified (size), the system interprets the value as an explicit burst
limit size. The value is expressed as an integer and by default is interpreted as the burst limit
in Kilobytes. If the value is intended to be interpreted in bytes, the byte qualifier must be
added following size.
Values 1 to 1000000
Default No default for size, use the default keyword to specify default
burst limit
To Next Page
Loading...
