Service Egress and Ingress QoS Policies
Quality of Service Guide 373
Priority This parameter specifies the default enqueuing priority overrides for all
packets received on an ingress SAP using this policy that match this rule.
High
Specifies that the high enqueuing parameter for a packet increases the
likelihood of enqueuing the packet when the ingress queue is congested.
Low
Specifies that the low enqueuing parameter for a packet decreases the
likelihood of enqueuing the packet when the ingress queue is congested.
Prec Specifies the forwarding class or enqueuing priority when a packet is
marked with an IP precedence value (ip-prec-value).
UCastQ Specifies the default unicast forwarding type queue mapping.
MCastQ Specifies the overrides for the default multicast forwarding type queue
mapping.
BCastQ Specifies the default broadcast forwarding type queue mapping.
UnknownQ Specifies the default unknown unicast forwarding type queue mapping.
Match Criteria Specifies an IP or MAC criteria entry for the policy.
Entry
Source IP Specifies a source IP address range used for an ingress SAP QoS policy
match.
Source Port Specifies a source TCP or UDP port number or port range used for an
ingress SAP QoS policy match.
Protocol Specifies the IP protocol number to be used for an ingress SAP QoS
policy match.
DSCP Specifies a DiffServ Code Point (DSCP) name used for an ingress SAP
QoS policy match.
Fragment True
Configures a match on all fragmented IP packets.
False
Configures a match on all non-fragmented IP packets.
FC Specifies the entry’s forwarding class.
Priority Specifies the default enqueuing priority overrides for all packets received
on an ingress SAP using this policy.
Src MAC Specifies a source MAC address or range to be used as a Service Ingress
QoS policy match.
Dst MAC Specifies a destination MAC address or range to be used as a Service
Ingress QoS policy match.
Dot1p Specifies a IEEE 802.1p value to be used as the match.
Snap-pid Specifies an IEEE 802.3 LLC SNAP Ethernet Frame PID value to be used
as a Service Ingress QoS policy match.
Ethernet-type Specifies an Ethernet type II Ethertype value to be used as a Service
Ingress QoS policy match.
Label Description (Continued)
To Next Page
Loading...
