Service Egress and Ingress QoS Policies
Quality of Service Guide 379
Policy-Id Scope Name Description
-------------------------------------------------------------------------------
1 Template default Default SAP ingress QoS policy.
10 Template
20 Template
-------------------------------------------------------------------------------
Number of policies : 3
-------------------------------------------------------------------------------
===============================================================================
*A:#
sap-egress
Syntax sap-egress [policy-id] [association | match-criteria | hsmda | detail]
Context show>qos
Description This command displays SAP egress QoS policy information.
Special Cases SAP Egress Output — The following table describes SAP egress show command output.
Label Description
Policy-Id The ID that uniquely identifies the policy.
Scope Exclusive
Implies that this policy can only be applied to a single SAP.
Template
Implies that this policy can be applied to multiple SAPs on the router.
Description A text string that helps identify the policy’s context in the configuration
file.
Queue:
CIR Admin Specifies the administrative Committed Information Rate (CIR)
parameters for the queue. The CIR defines the rate at which the system
prioritizes the queue over other queues competing for the same
bandwidth.
CIR Oper The operational value derived by computing the CIR value from the
administrative CIR and PIR values and their corresponding adaptation
rules.
CIR Rule min
The operational CIR for the queue will be equal to or greater than the
administrative rate specified using the rate command except where the
derived operational CIR is greater than the operational PIR. If the derived
operational CIR is greater than the derived operational PIR, the
operational CIR will be made equal to the operational PIR.
To Next Page
Loading...
