QoS Queue Group Template Command Reference
454 Quality of Service Guide
port-parent
Syntax port-parent [weight weight] [level level] [cir-weight cir-weight] [cir-level cir-level]
no port-parent
Context config>qos>qgrps>egr>qgrp>queue
Description This command defines the port scheduling parameters used to control the queues behavior when a
virtual egress port scheduling is enabled where the egress queue group template is applied. The port-
parent command follows the same behavior and provisioning characteristics as the parent command in
the SAP egress QoS policy. The port-parent command is mutually exclusive with the parent command.
The no form of the command removes the values from the configuration.
Default none
Parameters weight weight — Defines the weight the queue or scheduler will use at the above-cir port priority
level (defined by the level parameter).
Values 0 to 100
Default 1
level level — Defines the port priority the queue or scheduler will use to receive bandwidth for its
above-cir offered-load.
Values 1 to 8 (8 is the highest priority)
Default 1
cir-weight cir-weight — Defines the weight the queue or scheduler will use at the within-cir port
priority level (defined by the cir-level parameter). The weight is specified as an integer value
from 0 to 100 with 100 being the highest weight. When the cir-weight parameter is set to a
value of 0 (the default value), the queue or scheduler does not receive bandwidth during the
port schedulers within-cir pass and the cir-level parameter is ignored. If the cir-weight
parameter is 1 or greater, the cir-level parameter comes into play.
Values 0 to 100
cir-level cir-level — Defines the port priority the queue or scheduler will use to receive
bandwidth for its within-cir offered-load. If the cir-weight parameter is set to a value of 0 (the
default value), the queue or scheduler does not receive bandwidth during the port schedulers
within-cir pass and the cir-level parameter is ignored. If the cir-weight parameter is 1 or
greater, the cir-level parameter comes into play.
Values 0 to 8 (8 is the highest priority)
Default 0
queue-delay
Syntax queue-delay delay
no queue-delay
To Next Page
Loading...
