Alcatel-Lucent 7450 - Page 554

Overview
554 Quality of Service Guide
| | | OnTheWireRates:false
| | | ATMOnTheWireRates:false
| | | LastMileOnTheWireRates:false
| |
| |--(Q) : 1->lag-30(3/2/1)->1
| | | AdminPIR:1000000 AdminCIR:0
| | | Parent Limit Unused Bandwidth: not-found
| | | AvgFrmOv:101.65(*)
| | | CBS:0 B MBS:1253376 B
| | | Depth:1105728 B HiPrio:147456 B
| | |
| | | [CIR]
| | | Assigned:0 Offered:0
| | | Consumed:0
| | |
| | | [PIR]
| | | Assigned:135498 Offered:1000000
| | | Consumed:135498
| | |
| | | OperPIR:135625 OperCIR:0
| | |
| | | PktByteOffset:add 0*
| | | OnTheWireRates:false
| | | ATMOnTheWireRates:false
| | | LastMileOnTheWireRates:false
| |
===============================================================================
*B:ALU-A>config>qos>port-sched-plcy#
The following output shows the max-rate percent value.
*B:ALU-A>config>qos>port-sched-plcy# info
----------------------------------------------
max-rate percent 50.00
----------------------------------------------
With max-rate percent, the max-rate is capped to the percent of the active LAG capacity.
When max-rate is configured as percentage and the dist-lag-rate-shared is ignored.
The group rate, level pir and cir rate can be entered as percent.
*B:ALU-A>config>qos>port-sched-plcy# info
----------------------------------------------
dist-lag-rate-shared
max-rate percent 30.00
group "test" create
percent-rate 20.00 cir 20.00
exit
level 1 percent-rate 10.00 percent-cir 10.00
level 2 percent-rate 20.00 percent-cir 20.00
level 3 percent-rate 30.00 percent-cir 30.00
level 4 percent-rate 40.00 percent-cir 40.00
level 5 percent-rate 50.00 percent-cir 50.00