Slope QoS Policies
Quality of Service Guide 633
Context config>qos
Description This command copies existing QoS policy entries for a QoS policy-id to another QoS policy-id.
The copy command is a configuration level maintenance tool used to create new policies using existing
policies. It also allows bulk modifications to an existing policy with the use of the overwrite keyword.
Parameters slope-policy — Indicates that the source policy ID and the destination policy ID are slope policy
IDs. Specify the source policy ID that the copy command will attempt to copy from and
specify the destination policy ID to which the command will copy a duplicate of the policy.
overwrite — Specifies to replace the existing destination policy. Everything in the existing
destination policy will be overwritten with the contents of the source policy. If overwrite is
not specified, an error will occur if the destination policy ID exists.
ALA-7>config>qos# copy slope-policy default sp1
MINOR: CLI Destination "sp1" exists - use {overwrite}.
ALA-7>config>qos#overwrite
Slope Policy QoS Commands
slope-policy
Syntax [no] slope-policy name
Context config>qos
Description This command enables the context to configure a QoS slope policy.
Default slope-policy “default”
Parameters name — The name of the slope policy.
Values Valid names consist of any string up to 32 characters long
composed of printable, 7-bit ASCII characters. If the string
contains special characters (#, $, spaces, etc.), the entire string
must be enclosed within double quotes.
time-average-factor
Syntax time-average-factor value
no time-average-factor
Context config>qos>slope-policy
To Next Page
Loading...
