Slope QoS Policies
Quality of Service Guide 635
high-slope
Syntax [no] high-slope
Context config>qos>slope-policy
Description The high-slope context contains the commands and parameters for defining the high Random Early
Detection (RED) slope graph. Each buffer pool supports a high RED slope for managing access to the
shared portion of the buffer pool for in-profile packets.
The high-slope parameters can be changed at any time and the affected buffer pool high RED slopes
will be adjusted appropriately.
The no form of this command restores the high slope configuration commands to the default values. If
the commands within high-slope are set to the default parameters, the high-slope node will not appear
in save config and show config output unless the detail parameter is present.
low-slope
Syntax [no] low-slope
Context config>qos>slope-policy
Description The low-slope context contains the commands and parameters for defining the low Random Early
Detection (RED) slope graph. Each buffer pool supports a low RED slope for managing access to the
shared portion of the buffer pool for low out-of-profile packets.
The low-slope parameters can be changed at any time and the affected buffer pool low RED slopes
must be adjusted appropriately.
The no form of this command restores the low slope configuration commands to the default values. If
the leaf commands within low-slope are set to the default parameters, the low-slope node will not
appear in save config and show config output unless the detail parameter is present.
RED Slope Commands
max-avg
Syntax max-avg percent
no max-avg
Context config>qos>slope-policy>exceed-slope
config>qos>slope-policy>high-slope
config>qos>slope-policy>low-slope
To Next Page
Loading...
