Shared-Queue QoS Policies
Quality of Service Guide 649
IES Services
Use the following CLI syntax to apply the default policy to an IES service:
CLI Syntax: config>service# ies service-id
interface interface-name
sap sap-id
ingress
qos policy-id [shared-queuing
|multipoint-shared]
The following output displays an IES service configuration with SAP ingress policy 100
applied to the SAP with shared-queuing enabled.
A:SR>config>service# info
----------------------------------------------
ies 88 customer 8 vpn 88 create
interface "Sector A" create
sap 1/1/1.2.2 create
ingress
qos 100 multipoint-shared
exit
exit
exit
no shutdown
exit
----------------------------------------------
A:SR>config>service#
VPLS Services
Use the following CLI syntax to apply the default shared-queue policy to an ingress VPLS
SAP:
CLI Syntax: config>service# vpls service-id [customer customer-id]
sap sap-id
ingress
qos policy-id [shared-queuing | multipoint-
shared]
The following output displays a VPLS service configuration with SAP ingress policy 100
with shared-queuing enabled.
A:SR>config>service# info
----------------------------------------------
vpls 700 customer 7 vpn 700 create
description "test"
sap 1/1/9:0 create
ingress
qos 100 multipoint-shared
To Next Page
Loading...
