Overview
670 Quality of Service Guide
For information about the tasks and commands necessary to access the command line
interface and to configure and maintain your router, refer to CLI Usage chapter in the System
Basic Configuration Guide.
Basic Configurations
A advanced QoS policy must conform to the following:
• Each advanced policy must have a unique policy ID.
• Default values can be modified but parameters cannot be deleted.
Create an Advanced QoS Policy
Configuring and applying advanced policies is optional. If no advanced policy is explicitly
applied to a SAP or IP interface, then no default advanced policy is applied.
To create a new advanced policy, define the following:
• A slope policy ID value. The system will not dynamically assign a value.
• Include a description. The description provides a brief overview of policy features.
• The child control parameters, parameters that are intended to allow more precise
control of the method that hierarchical virtual scheduling employs to emulate the
effect of a scheduling context upon a member child queue or policer.
The following displays an example of an advanced policy configuration:
ALA-7>config>qos# info
#------------------------------------------
echo "QoS Policies Configuration"
#------------------------------------------
...
adv-config-policy "childPolicy1" create
description "Test"
child-control
offered-measurement
add percent 30
granularity percent 30
exit
bandwidth-distribution
above-offered-cap percent 5
granularity percent 5
exit
exit
exit
...
#------------------------------------------
To Next Page
Loading...
