Advanced QoS Policy Command Reference
678 Quality of Service Guide
While the system maintains default values for the advanced configuration parameters, no default adv-
config-policy exists.
The no form of this command removes the specified advanced policy.
Default None
Parameters policy-name — The name of the advanced QoS policy. A policy-name must be specified and
conform to the policy naming guidelines. If the specified name does not exist, the optional
create keyword requirements are met and the total number of policies per system will not be
exceeded, an adv-config-policy of that name will be created. If the specified name does exist,
the system will switch context to that adv-config-policy for the purpose of modification of
the policy’s contents.
Values Valid names consist of any string up to 32 characters long
composed of printable, 7-bit ASCII characters. If the string
contains special characters (#, $, spaces, etc.), the entire string
must be enclosed within double quotes.
child-control
Syntax child-control
Context config>qos>adv-config-policy
Description This command contains parameters that are intended to allow more precise control of the method that
hierarchical virtual scheduling employs to emulate the effect of a scheduling context upon a member
child queue or policer.
This command edits the parameters that control the child requested bandwidth and parental bandwidth
distribution for all policers and queues associated with the policy.
offered-measurement
Syntax offered-measurement
Context config>qos>adv-config-policy>child-control
Description This command modifies the offered rate measurement used to determine the bandwidth the queue or
policer is requesting from its parent virtual scheduling context.
This command modifies the parameters that control the child requested bandwidth for all policers and
queues associated with the policy.
add
Syntax [no] add {percent percent-of-admin-pir | rate rate-in-kilobits-per-second} [min-only | active-
To Next Page
Loading...
