ATM QoS Policy Command Reference
714 Quality of Service Guide
Sample Output
A:ALA-48>config>service>ies# show service sap-using sap 1/3/2:244/1
===============================================================================
Service Access Points Using Port 1/3/2:15990785
===============================================================================
PortId SvcId I.QoS I.Fltr E.QoS E.Fltr A.Pol Adm Opr
-------------------------------------------------------------------------------
1/3/2:244/1 89 1 none 1 none none Up Down
-------------------------------------------------------------------------------
Number of SAPs : 1
-------------------------------------------------------------------------------
===============================================================================
A:ALA-48>config>service>ies#
port
Syntax port [port-id] atm
port [port-id] atm connections
port [port-id] atm interface-connections
port [port-id] atm pvc
port [port-id] atm pvp
port [port-id] atm pvt
Context show
Description This command displays port or channel information.
Parameters port-id — Specifies the physical port ID.
Table 57: SAP Output Fields
Label Description
Port ID The ID of the access port where the SAP is defined.
Svc ID The service identifier.
SapMTU The SAP MTU value.
I.QoS The SAP ingress QoS policy number specified on the ingress SAP.
I.MAC/IP The MAC or IP filter policy ID applied to the ingress SAP.
E.QoS The SAP egress QoS policy number specified on the egress SAP.
E.Mac/IP The MAC or IP filter policy ID applied to the egress SAP.
A.Pol The accounting policy ID assigned to the SAP.
Adm The desired state of the SAP.
Opr The actual state of the SAP.
To Next Page
Loading...
