ATM QoS Policy Command Reference
716 Quality of Service Guide
Table 58: Show Port ATM PVC VPI/VCI Detail Output Fields
Label Description
Port Id Displays the port ID.
VPI/VCI Displays the VPI/VCI values.
Admin State Displays the administrative state of the interface connection.
Oper State Indicates the status of the ATM interface.
OAM State Indicates the OAM operational status of ATM connections.
ETE indicates end-to-end connection.
AIS denotes alarm indication signal.
RDI denotes for remote defect indication.
AIS-LOC indicates the alarm was due to loss of continuity of periodic
loopbacks.
Encap Type Indicates the encapsulation type.
Owner Identifies the system entity that owns a specific ATM connection.
AAL Type Displays ATM Adaptation Layer 5 (AAL5) information.
Endpoint Type Displays the endpoint type.
Cast Type Indicates the connection topology type.
Type Indicates the connection type.
Ing. Td Idx Specifies the ATM traffic descriptor profile that applies to the receive
direction of the interface connection.
Egr. Td Idx Specifies the ATM traffic descriptor profile that applies to the
transmit direction of the interface connection.
Last Changed Indicates the date and time when the interface connection entered its
current operational state.
Octets Displays the number of input and output octets.
HEC discarded cells are not included in the input octet numbers.
Cells Displays the number of input and output cells.
HEC discarded cells are not included in the input cell numbers.
Packets Displays the number of input and output packets.
Packets discarded due to HEC or oversize discards are not counted.
CRC errored are also in the packet counts and display on the VC level
statistics but not on the port level.
Dropped Packets Displays the number of packets dropped by the ATM SAR device.
To Next Page
Loading...
