126 Rockwell Automation Publication 2097-UM001D-EN-P - November 2012
Chapter 6 Configure and Start Up the Kinetix300 Drive
Keypad Input
The Kinetix 300 drive is equipped with a diagnostic status indicator and three
push buttons that are used to select displayed information and to edit a limited
set of parameter values. You can scroll the parameters by using . To view a
value, press . To return to Scroll mode press again.
When you press on editable parameters, the yellow status indicator (C)
blinks indicating that the parameter value can be changed. Use to change
the value. Press to store the new setting and return to Scroll mode.
Table 60 - Status Display Information
Status Indicator Description
StAt Current drive status - run = drive running, diS = drive disabled, EXX = Drive fault, where XX
is the fault code.
Hx.xx Hardware revision. For example, H2.00.
Fx.xx Firmware revision. For example, F2.06.
FLtS Stored fault's history. You can scroll through stored faults E0XX…E7XX, where XX is the
fault code.
Ht Heatsink temperature. Heatsink temperature in is shown ºC if greater than 40 ºC. Otherwise
‘LO (low) is displayed.
EnC Encoder activity. Primary encoder counts are displayed for encoder diagnostics.
buS Displays drive DC bus voltage.
Curr Displays motor's phase current (RMS). Shows current value if drive is enabled, otherwise
shows DiS.
boot 0 = autostart disabled, 1 = autostart enabled.
dHCP Ethernet DHCP Configuration: 0=dHCP is disabled; 1=dHCP is enabled.
IP_1 First octet of the IP address.
IP_2 Second octet of the IP address.
IP_3 Third octet of the IP address.
IP_4 Fourth octet of the IP address (changeable).
To Next Page
Loading...
